analysismor.blogg.se

Memory stick ind and mstk pro indoor
Memory stick ind and mstk pro indoor










  1. #Memory stick ind and mstk pro indoor how to#
  2. #Memory stick ind and mstk pro indoor manual#

Normal voltage output is 24-26 Volts AC.Īmperage over draw on the pump start or master valve circuit. A transformer can be tested with a voltmeter. If the display goes blank after removing the battery, the transformer could be damaged and may need to be replaced. If you can verify that you have power to the outlet, disconnect the backup battery from the controller. Have an electrician check your GFI, circuit breaker, and electrical outlet if you do not have power to the outlet.

memory stick ind and mstk pro indoor

If you do not have power to the outlet, check all wall switches, timers, or power strips that may be connected to the outlet. Controllers that are hardwired to the power source will need to be tested by a qualified electrician. If your controller is not plugged into a wall outlet, the power source is hardwired. The controller is running on the power supplied by the backup battery.Ĭheck the power source by plugging a lamp or radio into the wall outlet to verify there is power at the outlet. The NO or NO AC display is a diagnostic message telling you that the controller has stopped receiving AC power. Why does my controller display show "NO" or "NO AC"?

  • How do I address the Wireless Solar Sync sensor to the Solar Sync receiver.
  • How do I set Seasonal Adjustment on my Pro-C controller?.
  • How many stations can I run at one time using the Pro-C's programming.
  • How do I program or remove a delay between stations on my Pro-C controller?.
  • How do I program Odd or Even Day Watering on my Hunter Pro-C controller?.
  • How do I program Interval Days on my Hunter X-Core controller?.
  • How do I program or remove a delay between stations on my XC or X-Core controller?.
  • memory stick ind and mstk pro indoor

    #Memory stick ind and mstk pro indoor how to#

    Watch the four-part video series on the right or follow the links below for more detailed instructions on how to program your controller.

    memory stick ind and mstk pro indoor

    When the station or stations finish watering the controller will go back to normal automatic operation.

    #Memory stick ind and mstk pro indoor manual#

    To do so, turn the dial to Manual Single Station or Manual All Stations, verify that the stations that you want to activate have run time, and turn the dial back to the Run position. Hunter controllers allow you to start a station or an entire program manually.

  • Greenhouse, Nursery, and Open-Field Irrigation.











  • Memory stick ind and mstk pro indoor